Hi I need the schematic for Dynacord POwermate 2200 .The service manual for powermate 1000\1600\2200 is same except low voltage power supply of 2200 .Kindly help the over heating problem
Hi, I guess it is the power amp that's overheating? This is mostly caused by a faulty bias trimmer. This is the one with 100 or 250 ohms if I remember correctly. Replace them on both sides with good quality ones (cermet or similar).
For the bias setting I may be able to find a service manual but it could take some time to look it up.
Design and Content © HiFi Engine 2006-2016
FAQ | Site Policy