I'm looking for NAD 614 Service Manual
The problem of my NAD 614 is, that after switch on and inserting the cassette the cassette insert is looked but no further reaction on any pressed buttom. Meanwhile also the Display stay off, but the cassette insert is still lookd, even when the tape deck is switched off. Any ideas or hints?
Thanks a lot, Matthias
If you have no display it might be a power supply problem, which could also affect the tape deck sensors and operation.
Yes this was also my idea, therefore today I finished to open the deck and remove the unwound cassette inside (the capstan was still working while all other functions incl. display and buttons are out of service).
When switching on the capstan starts running. After some seconds it stops, but no other function at all, except the mechanical when inserting the gear-wheel for moving up the head section. The question is now: Where to start?
Design and Content © HiFi Engine 2006-2016
FAQ | Site Policy