AM/FM Stereo Receiver (1974)
The SX-1010 is Pioneer's top of the line FM/MW stereo receiver.
Features include an FM front end with dual-gate FETs, ceramic filters and ics in IF stages for sharp selectivity, quadrature detection, phase lock loop (PLL) stereo demodulator, all IC equipped AM section with linear dial, balanced positive and negative power supply with heavy duty components, and a phono equalizer with wide dynamic range and extremely close tolerances.
The twin tone controls permit precise shaping of sound and direct-coupled power amplifier supplies high output power with minimum distortion.
Tuning range: FM, MW
Power output: 100 watts per channel into 8Ω (stereo)
Frequency response: 10Hz to 40kHz
Total harmonic distortion: 0.1%
Damping factor: 30
Input sensitivity: 2mV (mic), 2.5mV (MM), 150mV (DIN), 150mV (line)
Signal to noise ratio: 65dB (mic), 70dB (MM), 95dB (line)
Output: 150mV (line), 30mV (DIN), 1V (Pre out)
Speaker load impedance: 4Ω to 16Ω
Semiconductors: 3 x FET, 5 x IC, 73 x transistors, 41 x diodes
Dimensions: 520 x 175 x 440mm
Accessories: FM T-type antenna
If you have additional documentation please consider donating a copy to our free archive.
NOTE If you are having problems opening files please read this thread.
All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited. This website is not affiliated with or sponsored by Pioneer. If you wish to purchase a SX-1010 please contact the company via their website or visit an authorised retailer.