hifi engine

Library / Pioneer

Pioneer SX-950

AM/FM Stereo Receiver

Pioneer SX-950

Description

High power and extraordinary FM sensitivity in an advanced circuitry AM/FM receiver.

How much AM/FM receiver can you get for a pleasantly modest investment? Try the Pioneer SX-950 on for size.

This distinctive package of plenty includes up-to-the-minute circuitry throughout its handsome construction, and then gives plenty of power to boot: continuous power output of 85 watts per channel min RMS at 8 ohms, from 20 Hertz to 20,000 Hertz with no more than 0.1% total harmonic distortion.

But big power is only one important attribute of this new receiver - you also get an FM front end that performs with outstanding stability and sensitivity, thanks to the use of a pair of dual gate MOS FETs in its RF amplifier and mixer, an advanced FM IF section that includes three 2-element ceramic filters and a large scale integrated circuit, plus a multiplex section for FM stereo broadcasts that uses the innovative and advanced phase-locked loop IC for excellent separation characteristics.

The result is a flawless kind of sound that is unmatched in tonal quality by any comparably-priced receiver now on the market, plus the radiant good looks of Pioneer design and human engineering. The SX-950 by Pioneer: Something extra everywhere.

Specifications

Tuning range: FM, MW

Power output: 85 watts per channel into 8Ω (stereo)

Frequency response: 15Hz to 40kHz

Total harmonic distortion: 0.1%

Damping factor: 25

Input sensitivity: 6.5mV (mic), 2.5mV (MM), 150mV (DIN), 150mV (line)

Signal to noise ratio: 75dB (MM), 90dB (line)

Output: 150mV (line), 30mV (DIN), 1V (Pre out)

Speaker load impedance: 4Ω (minimum)

Semiconductors: 4 x FET, 4 x IC, 55 x transistors, 36 x diodes

Dimensions: 526.6 x 173 x 411.5mm

Weight: 19.1kg

Accessories: FM T-type antenna

Downloads

brochure (en)

service manual (en)

instruction/owners manual (en) - xystus

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.

Pioneer Receivers

Comments

re: SX-950

I just purchased one of these beauties. Should the power (on/off) lever move as lightly as all of the over levers, or does it typically have more resistance? Comments appreciated. Jon

re: SX-950

The picture I believe showed the line voltage fuse accessable from the back of the case. But mine was inside the case accessed from the bottom panel. It is 6A-125V and mine was blown! I sure hope that is all that is wrong! But I have sprayed everything down with Deoxit D5 which goes really fast so a little goes a long way.
My Pioneer SX-737 I will open next because I seem to have the left side speaker just humming and not picking up a signal. Hopefully it is either a fuse, or the incoming signal was bad because I was testing it with an old DVD player on CD. These two tuners really put out some great sound when they are working well. I am a Noeb on this stuff, though I have had verious elecrical classes over the years. My old way was just cleaning and taking a eyeglass and searching for cracks or burns. But I need to get familiar with finding leaky pots and checking resistors.

re: SX-950

My left stereo channel goes out after unit warms up. Sound still comes out in mono mode, but not stereo. Anyone know what I can do to address this problem?

parts list of power amplifier ass'y (AWH-050)

resistors listing, page 80, VR1 and VR2 shows 1K-B; it should be 10K-B.

 

This website is not affiliated with or sponsored by Pioneer. To purchase a SX-950 please contact the company via their website or visit an authorised retailer.