Stereo Integrated Amplifier (1981-82)
Power output: 20 watts per channel into 8Ω (stereo)
Frequency response: 40Hz to 20kHz
Total harmonic distortion: 0.3%
Damping factor: 30
Input sensitivity: 3mV (MM), 150mV (line)
Signal to noise ratio: 70dB (MM), 90dB (line)
Channel separation: 50dB (line)
Output: 150mV (line), 30mV (DIN)
Speaker load impedance: 4Ω to 16Ω
Dimensions: 440 x 75 x 322mm
If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.
If you have additional documentation please consider donating a copy to our free archive.
Reviewed May 08th, 2014 by lavazza
An old but very good amplifier and after more than 15 years of downtime!
My new amplifier sony refused to function after 2 hours at higher volume and then I remembered my good friend ... with few parasites per volume at first but it did and still 2 months goes .Old but good!
Reviewed Jun 18th, 2013 by Casper-1985
Having just recently put my old Akai AM-U11 amplifier into daily use after years of retirement, When my Modern NAD amplifier unfortunately died of unknown causes.
I must say that I am deeply impressed with the sound coming from this old piece of equipment, in my opinion, Akai AM-U11 fully capable of delivering a good sophisticated sound experience even for today's standards.
when talking power the Akai AM-U11 stereo Amplifier is far from the most powerful, but honestly I think it does a fantastic job with what it has available
Despite the lack of power it still manage To get good sound out of my relatively large speakers.
I intent to get my NAD amplifier up and running again
but I'm not in a hurry, my old Akai is doing alright!