HH Scott 380R
AM/FM Stereo Receiver
Tuning range: FM, MW
Power output: 85 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 20kHz
Total harmonic distortion: 0.03%
Damping factor: 100
Input sensitivity: 2.5mV (MM), 150mV (line)
Signal to noise ratio: 90dB (MM), 95dB (line)
Channel separation: 70dB (MM), 75dB (line)
Dimensions: 152 x 530 x 330mm
If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.
If you have additional documentation please consider donating a copy to our free archive.
Reviewed May 05th, 2015 by Beardg
This was one of the last great receivers made by HH Scott during their SS years. Great tuner, excellent phono pre-amps(2),and underrated power. This receiver used the same amplifier as their TOTL integrated and separate amplifiers from that year,just a small reduction in output.Totally under appreciated, they can be found cheap on ebay..The 380R and the 390R are the TOTL amps, better than many separates from that period,or even today.The lower models, 320R,350R,370R are fine receivers but have lesser quality tuners and amps,though still quite a bit better than many more popular receivers from that time. Mine is close to 40 years old(I am original owner) and the unit has been gone through by Vince at Audio Proz in Watertown Mass, though still working, he did clean up a few things and replaced bulbs ect. Now powering a pair of SNELL TYPE C speakers,though 85 watts is on the low side for these speakers, the Scott performs well, handles a 4ohm load no problem and gets very loud with no distortion.