hifi engine

Manual Library / Jason

Jason J2-10

Stereophonic Amplifier

add a review add a review

Jason J2-10


The Jason Amplifier J2-10 mkIII is probably the most advanced design of stereophonic amplifier available in England today.

It is a complete dual 10 watt amplifier with adequate reserve of power. In fact 15 watts sine wave can be measured at low distortion.

The integral pre-amplifier has sufficient sensitivity to play directly from a magnetic pick-up or tape head. The J2-10 also may be used as a very satisfactory single channel amplifier if the user is not yet ready for stereophonic reproduction.

To obtain stereo, it is necessary to have a minimum of two separate channels from the beginning at the microphone right through to the loudspeakers, and these channels must be completely independent. Two separate amplifiers could be used, but for convenience they are built on the same chassis with ganged controls.

It can be seen therefore, that if the sound source is on the left then it may be reproduced from the left hand speaker while if the soloist is in the middle then the sound source will be reproduced by both speakers and will appear to come from a point between them.


Power output: 10 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 100kHz

Total harmonic distortion: 0.1%

Input sensitivity: 3mV (mic), 4mV (MM), 80mV (ceramic), 80mV (line)

Signal to noise ratio: 45dB (mic), 55dB (MM), 55dB (ceramic), 60dB (line)

Output: 150mV (line)

Speaker load impedance: 4Ω to 16Ω

Valve complement: 4 x EL84, 4 x ECC81, 3 x ECC83, 1 x GZ34

Dimensions: 15 x 4-3/8 x 12 inches

Weight: 24lbs


mkIII instruction/owners manual   English - TOMPRO

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


This website is not affiliated with or sponsored by Jason. To purchase J2-10 spares or accessories, please contact the company via their website or visit an authorised retailer.