hifi engine

Manual Library / Kenwood

Kenwood 107VR

Audio Video Surround Receiver (1997)

add a review add a review

Kenwood 107VR


Tuning range: FM, MW

Power output: 120 watts per channel into 8Ω (stereo)

Surround output: 120W (front), 120W (center), 120W (rear)

Frequency response: 40Hz to 20kHz

Total harmonic distortion: 0.3%

Input sensitivity: 3mV (MM), 220mV (line)

Signal to noise ratio: 75dB (MM), 93dB (line)

Output: 1V (Pre out)

Speaker load impedance: 8Ω (minimum)

Video Connections: composite

Dimensions: 440 x 127 x 389mm

Weight: 9kg

Accessories: remote control

Year: 1997


service manual   English - AlkatrazBR

service manual (alt scan)  English - akradiabra

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


re: 107VR

As it turns out, I should hae a simple fix, but i sure do appreciate having the documentation on this baby! If I wiggle the connector to the A speaker Left, it comes and goes. Why didn't I try that before replacing the wires :D I had some 14 ga. wire to upgrade with anyway. Even with a simple fix ahead, it's good to know what I'm getting into before I start. Exploded view shows it is a board mounted connector screwed to the back panel.

Thanks for providing this!!!


This website is not affiliated with or sponsored by Kenwood. To purchase 107VR spares or accessories, please contact the company via their website or visit an authorised retailer.