Stereo Integrated Amplifier (1980)
Power output: 55 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 20kHz
Total harmonic distortion: 0.05%
Damping factor: 45
Input sensitivity: 2.5mV (mic), 2.5mV (MM), 150mV (line)
Signal to noise ratio: 73dB (mic), 77dB (MM), 105dB (line)
Output: 150mV (line), 30mV (DIN)
Speaker load impedance: 4Ω to 16Ω
Dimensions: 400 x 139 x 296mm
If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.
If you have additional documentation please consider donating a copy to our free archive.
Reviewed May 11th, 2015 by charlyphoto
Reviewed May 12th, 2014 by PlasticTiger
I've owned and used this amplifier for the past 15 years and it has never, ever let me down. The toggle switches for the tone control and tape select are getting a bit scratchy but we all know that's expected in a a 35 year old amplifier. It's built like a tank and can handle being dropped. I know because mine was dropped as it has one corner bent! Great sound, can even handle floor monitors in live band situation at halfway volume! looks awesome too.
Reviewed May 31st, 2013 by Smoke Screen
Bigger brother of the KA-305 base line integrated with
beefed up power amp and features and a nice faceplate
design with vu-meters. Single opamp phono pre
based on a HA1457 chip. Line amp is a NJM4558D.
Simple but good power amp. Lots of cheap coupling
caps in the signal path. Overall a decent amp that was
expensive back then and mostly is now used. Better look