Solid State Stereo Amplifier (1973-76)
The Kenwood KA-6004 achieves an overall high level of reliability in every performance phase.
If only the strictest requirements are met by each component, then they are included in the full assembly potential of this outstandingly unique amplifier.
For example, the pre-amplifier uses a new type of can seal (metal cased) transistor which is capable of off setting the usual characteristic deterioration in signal to noise ratio resulting from humidity and temperature wear.
Low noise PNP transistors have been attached to the top of the equalizer circuit. Also, super high nichrome evaporated metal film resistors have been used in the feedback circuit in the equalizer stage. These same resistors are also equipped in all other significant circuits to vastly improve signal to noise ratio.
Power output: 40 watts per channel into 8Ω (stereo)
Total harmonic distortion: 0.5%
Damping factor: 32
Input sensitivity: 3mV (mic), 2.5mV (MM), 200mV (line)
Signal to noise ratio: 70dB (mic), 68dB (MM), 75dB (line)
Output: 200mV (line), 40mV (DIN)
Speaker load impedance: 4Ω to 16Ω
Dimensions: 435 x 153 x 300mm
If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.
If you have additional documentation please consider donating a copy to our free archive.
Reviewed Feb 26th, 2014 by marceloxxx007xxx007
watts are 40+40 wrms in 8 ohms top superior à¡udio quality . 1972 very good amplifier !