hifi engine

Manual Library / Kyocera

Kyocera A-710

Integrated Stereo Amplifier

add a review add a review

Kyocera A-710


Power output: 100 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.06%

Damping factor: 100

Input sensitivity: 0.15mV (MC), 2.2mV (MM), 200mV (line)

Signal to noise ratio: 65dB (MC), 85dB (MM), 105dB (line)

Speaker load impedance: 4Ω (minimum)

Dimensions: 430 x 155 x 438mm

Weight: 20kg


service manual   English - Ivy Caudieus

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


re: A-710 high noise floor

I have this on my bench for a complaint of high noise floor.
The power supply rails are clean, the volume control is noisy all the way through it's travel but the noise does not increase in volume with full rotation, the mute button seems particularly contributory to this noise when actuated. Acts much like a lifted ground. All the inputs sound good, aside from the high noise floor it still sounds quite good. I doubt the output transistors are bad.

This website is not affiliated with or sponsored by Kyocera. To purchase A-710 spares or accessories, please contact the company via their website or visit an authorised retailer.