hifi engine

Manual Library / Philips

Philips F4110

Stereo Integrated Amplifier

add a review add a review

Philips F4110


Power output: 25 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.7%

Input sensitivity: 2.5mV (MM), 150mV (line)

Speaker load impedance: 8Ω (minimum)

Dimensions: 420 x 80 x 302mm


service manual   Nederlands -

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


re: F4110

could someone explain how to connect 4 speakers to F4110?
each output is 8 Ohm or not?

Philips F4110

Thanks it's very good but not in English. I need to know how to
connect up the wires to play this amplifier. Any tips??
Kind regards


It depends what you are trying to attach to it? A CD player could be attached to the AUX input BU- 5 (this amp is pre CD so you may need to attenuate the signal to avoid distortion), A tuner to BU-1, a turntable with MM cartridge to BU-2 and a tape recorder to BU-3 (play) and BU-4 (record). There are then two sets of speaker outputs, BU-6 and BU-7 (A) and BU-8 and BU-9 (B). Ideally you would need 2-Pin DIN plugs for the speaker connections.


This website is not affiliated with or sponsored by Philips. To purchase F4110 spares or accessories, please contact the company via their website or visit an authorised retailer.