hifi engine

Manual Library / Pioneer

Pioneer SX-700T

AM/FM Solid State Receiver

add a review add a review

Pioneer SX-700T


Tuning range: FM, MW

Power output: 25 watts per channel into 8Ω (stereo)

Frequency response: 25Hz to 50kHz

Total harmonic distortion: 1%

Damping factor: 35

Input sensitivity: 2.1mV (MM), 190mV (line)

Signal to noise ratio: 75dB (MM), 85dB (line)

Speaker load impedance: 4Ω to 16Ω

Dimensions: 405 x 137 x 350mm

Weight: 9.1kg


operating/service manual   English - japa

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


re: SX-700T

Picked up this receiver about 8 months ago, had been cleaned and serviced. it worked very well until recently, when the AUX input, which I'm running computer audio through, seems to be about half the volume it had before. It reminds me of an old turntable I had in the 70's that required a small pre-amp between it and the receiver. Without the pre-amp, it was barely audible.

Does each section, tape, phono and Aux have separate "pre-amp", or is this a symptom of something else? The tape and phono seem to be outputting to "normal" volume levels (vol dial at about 9-10 O'clock is plenty loud).

Thanks in advance for any help on this.

This website is not affiliated with or sponsored by Pioneer. To purchase SX-700T spares or accessories, please contact the company via their website or visit an authorised retailer.