hifi engine

Manual Library / Realistic

Realistic SA-2000

Stereo Integrated Amplifier

add a review add a review

Realistic SA-2000


Power output: 60 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 70kHz

Total harmonic distortion: 0.03%

Input sensitivity: 2.6mV (MM), 165mV (line)

Signal to noise ratio: 65dB (MM), 85dB (line)

Channel separation: 50dB (line)

Output: 200mV (line)

Speaker load impedance: 4Ω to 16Ω


service manual   English - renzo54

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


re: SA-2000

Great amp, smaller than a thought it would be but very solid build quality. Other than a couple of dirty toggle switches it sounds pretty good for 38 years old, however will need a recap job for optimal performance. This amp is very accessible and well laid out and should be fairly easy to recap. Thankfully the slide volume switches work well on mine as they might be hard to come by. I will update after the recap.

re: SA-2000

I bought one of these new in 1974 or 75.
It is built pretty stout.

There was some crosstalk problem when a source was hooked up and on (tuner) and the tuner signal would leak into the phono input.

I took the case off and cut the wire ties near the source selector switch and separated the phono input wires from the rest of the bundle. It greatly reduced the leakage into the phono section from other sources.

This website is not affiliated with or sponsored by Realistic. To purchase SA-2000 spares or accessories, please contact the company via their website or visit an authorised retailer.