hifi engine

Manual Library / SAE

SAE A502

Dual High Resolution Power Amplifier

add a review add a review

SAE A502


Power output: 200 watts per channel into 8Ω (stereo), 600W into 8Ω (mono)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.025%

Damping factor: 125

Input sensitivity: 1V

Signal to noise ratio: 110dB

Speaker load impedance: 4Ω (minimum)

Dimensions: 483 x 356 x 133mm


schematic   English - fmmech

instruction/owners manual   English - Richard P. Krochmal

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


re: A502

Anyone have any advice/insight. I want to run 4ohm speakers in bridged mode with this amp. The back of the amp states 8 ohms bridged. No mention of 4 ohms. Will I damage the amp running speakers with less resistance?

re: SAE A502

My treasured SAE A502 amp gave off a burning smell the other day so I fear something in it overheated. Does anyone have any suggestions on where to get this repaired?

This website is not affiliated with or sponsored by SAE. To purchase A502 spares or accessories, please contact the company via their website or visit an authorised retailer.