hifi engine

Manual Library / Sansui

Sansui 350

Multiplex Stereo Tuner Amplifier (1968-70)

add a review add a review

Sansui 350


With most of the same design and performance features of the larger Sansui 800, this model is the most complete receiver available anywhere under 50 watts.

For better FM performance, it too, features a FET and 3-gang capacitor front end.

In addition to improved FM sensitivity and selectivity (SN ratio of better than 50db), the 350's FM section provides channel separation of better than 30db.

At home within a wide 30 to 20,000Hz power bandwidth, the 350 keeps distortion below a negligible 1% and features a damping factor of 34 at 8 ohms.

Other large receiver features include an ability to power up to two speaker systems, to operate off both 75 and 300 ohm antennas, and automatic FM mono stereo switching.


Tuning range: FM, MW

Power output: 18 watts per channel into 8Ω (stereo)

Frequency response: 30Hz to 20kHz

Total harmonic distortion: 1%

Damping factor: 34

Input sensitivity: 2.2mV (MM), 150mV (DIN), 150mV (line)

Signal to noise ratio: 60dB (MM), 65dB (line)

Output: 150mV (line)

Speaker load impedance: 8Ω (minimum)

Semiconductors: 31 x transistors, 21 x diodes, 4 x varistors

Dimensions: 4-1/2 x 15-13/16 x 13-1/8 inches

Weight: 19.5lbs

Year: 1968


panel info   English - rbucchino

Related Catalogues


If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


This website is not affiliated with or sponsored by Sansui. To purchase 350 spares or accessories, please contact the company via their website or visit an authorised retailer.