Integrated Stereo Amplifier (1975-76)
Power output: 42 watts per channel into 8Ω (stereo)
Frequency response: 10Hz to 40kHz
Total harmonic distortion: 0.15%
Damping factor: 30
Input sensitivity: 2.5mV (MM), 100mV (DIN), 100mV (line)
Signal to noise ratio: 70dB (MM), 85dB (DIN), 85dB (line)
Channel separation: 50dB (MM), 55dB (line)
Output: 100mV (line), 30mV (DIN), 0.8V (Pre out)
Speaker load impedance: 8Ω (minimum)
Semiconductors: 45 x transistors, 16 x diodes, 3 x zener diodes, 1 x LED
Dimensions: 434 x 130 x 315mm
If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.
If you have additional documentation please consider donating a copy to our free archive.
Reviewed Jul 06th, 2016 by augus1530
This Sansui AU-6600 never fails me since 1979 when my dad bought as a second-hand item. Ever since, I've been playing turntable through this amplifier with no issue & great sound ! It finally underwent an overhaul 2 years ago whereby the PCBA circuitries have to be replicated due to aging. Now it's back to perform equivalent to it's hey days crossing it's 41st anniversary since it's birth in 1975 !!!
Reviewed Jul 14th, 2014 by sevenseas7
I picked this up on ebay, the amp was restored by the seller (has good reputation for restoration work, fully recapped).
I have purchased a wide range of audio equipment, both tubes and solid state, over the years. This is one of my favorite amps. This amp is incapable of producing a bright sound, at least with the speakers I tested with it. What really impresses me is the highs are non-fatiguing, yet provide very good detail.
I listen to both vocals and instrumentals. Whether I'm listening to flute, piano, vibes, etc the presentation is very realistic. Vocals are good too, although I believe my tube amp has the edge (mids more forward than with this amp).
The headphone jack sounds excellent with my seinhauser hd600 headphones. Also includes 2 aux settings which gives me 3 usable settings, including tuner setting. I have not used the phono input.
Tone controls are effective in fine tuning your listening taste. Has a mute switch to turn down volume very low as well as loudness switch to boost low volume.
Black face with silver knobs with 1 red power light, very classy and subdued.
40 watts per channel. I have tested with speakers 90-98 db range. The amp pushes them with no problem.
One word of advice purchasing vintage integrated amps. Purchase them fully restored with a return policy. This may alter the sound due to new components but will provide you with years of trouble free service and in my opinion sound better with the right restoration.