Integrated Amplifier (1983)
For the first time Sansui Super Feed Forward technology is available in our popular high value series.
Specifications, particularly phono, are on a par with top-of-the-line models from other makers.
Super Feed Forward DC power amp. Dual-Bridge Rectifier circuit and toroidal power transformer for excellent power regulation. Fluorescent peak power meter. Phono equalizer for moving-magnet and moving-coil cartridges. Independent tape-record selector.
Power output: 70 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 20kHz
Total harmonic distortion: 0.004%
Damping factor: 50
Input sensitivity: 0.25mV (MC), 2.5mV (MM), 200mV (line)
Signal to noise ratio: 65dB (MC), 85dB (MM), 110dB (line)
Channel separation: 72dB (MM), 80dB (line)
Output: 200mV (line)
Speaker load impedance: 8Ω (minimum)
Dimensions: 430 x 112 x 334mm
If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.
If you have additional documentation please consider donating a copy to our free archive.
Sansui Integrated Amplifiers
Submitted by sondurum
Submitted by Smoke Screen
This is a good amplifier for those who no longer have
a turntable and dont need the phonopre,because despite
Sansui`s claim the phonosection in this amp is on par with
their high value units,the truth is its a single Opamp
cuircuit with a cheap and noisy Mitsubishi part and not on
par with earlier, cheaper units.