hifi engine

Manual Library / TEAC


Noise Reduction Unit (1972)

add a review add a review



The TEAC Dolby Noise Reduction System will enable you to make superior recordings at reduced tape speeds.

A prime reason for using the higher speeds was to reduce tape hiss, with the AN-80 tape hiss is electronically reduced in amplitude so that it is no longer a limiting factor in tape quality.

You will find that your slow speed recordings equal or surpass those you made in the past at higher tape speeds.

The Dolby System operates by processing the signal as it is fed to your tape recorder. Upon playback, the signal is unprocessed or returned to its original state.

Therefore the Noise Reduction Unit is connected into your audio system between your tape deck and the recording source, be it an amplifier, pre-amp or receiver.


Channels: 2

Input sensitivity: 30mV

Output level: 580mV

Noise reduction system: dolby

S/N improvement: 10dB (dolby)

Frequency response: 20Hz to 15kHz

Signal to noise ratio: 60dB

Total harmonic distortion: 0.5%

Channel separation: 50dB

Dimensions: 88 x 410 x 273mm

Weight: 4kg


instruction/owners manual   English - irasweiss

service manual   English - irasweiss

Related Catalogues

Noise Reduction Units

The Natural Sound Of

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


This website is not affiliated with or sponsored by TEAC. To purchase AN-80 spares or accessories, please contact the company via their website or visit an authorised retailer.