Stereo Integrated DC Amplifier (1984-86)
Power output: 100 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 20kHz
Total harmonic distortion: 0.003%
Damping factor: 80
Input sensitivity: 0.17mV (MC), 2.5mV (MM), 150mV (line)
Signal to noise ratio: 72dB (MC), 88dB (MM), 104dB (line)
Output: 150mV (line)
Speaker load impedance: 4Ω to 16Ω
Dimensions: 430 x 142 x 380mm
If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.
If you have additional documentation please consider donating a copy to our free archive.
Reviewed Apr 25th, 2016 by TEZ
Very clean & sweet-sounding amp, can listen for hours without fatigue!
Designed to be very linear, I've seen some comments that it is accurate, but not warm, probably depends on speakers & other factors, but I find it almost tube-like.
The original speaker connectors are horrible, in my opinion, so I replaced with banana plug jacks.
Also styling not the most attractive, again, my opinion, but if you can find one in good shape for a reasonable price ($100 or less), I think you will be very happy with it!
Reviewed Jul 11th, 2014 by levelone
Awesome Amp ! Clean.. Powerful. Has Copy Tape 1 and 2 for looping. Also has pre in pre out for looping or using as a pre amp. Love everything about this big powerful amp. 100 watts RMS in 8 is more than enough.. Very stiff amp. Only thing I might add would be a phono 2 , but that is nit picking.. If you can find one, grab it !! And enjoy...