Tuning range: FM, MW
Power output: 16 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 50kHz
Total harmonic distortion: 0.5%
Damping factor: 40
Input sensitivity: 3mV (mic), 3mV (MM), 150mV (line)
Signal to noise ratio: 65dB (mic), 72dB (MM), 85dB (line)
Channel separation: 50dB (MM), 50dB (line)
Output: 150mV (line), 0.2V (Pre out)
Speaker load impedance: 4Ω to 16Ω
Semiconductors: 4 x IC, 3 x FET, 38 x transistors, 22 x diodes, 1 x zener diodes, 2 x LED
Dimensions: 444 x 158 x 300mm
If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.
If you have additional documentation please consider donating a copy to our free archive.
Yamaha Stereo Receivers
Reviewed Apr 29th, 2012 by ghostrider05
I have had this receiver since the early '70's. Bought it new & paid like $350 for it then. Best electronic equipment I have ever owned. Sounds as good now as when it was new. Left channel has gone out recently and looking to get it fixed so I can continue to enjoy it.
Reviewed Sep 27th, 2015 by acwsoft
Solid built little receiver - does not have the look and feel of a Marantz 2215B 2216, but the tuner is above average and way better than today's digitrash. My CR-400 had a dead left channel (I replaced two power transistors and a fuse) and the power switch has a mechanical defect (always on) I will replace it tomorrow. The E-model has DIN plugs instead of RCA sockets so you'll need DIN RCA adaptors. The other low point is the woodcase which - after almost 40 years - is usually in rather poor state. Once the work is done it's a nice piece of vintage hifi.
Thanks for the manuals !