hifi engine

Manual Library / Yamaha

Yamaha HTR-5280

Audio Video Receiver

add a review (1 review)

Yamaha HTR-5280

Specifications

Tuning range: FM, MW

Power output: 100 watts per channel into 8Ω (stereo)

Surround output: 100W (front), 100W (center), 100W (rear)

Frequency response: 10Hz to 100kHz

Total harmonic distortion: 0.04%

Damping factor: 80

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 96dB (line)

Channel separation: 55dB (MM), 45dB (line)

Output: 150mV (line), 2.57V (Pre out)

Speaker load impedance: 4Ω (minimum)

Digital inputs: coaxial, optical

Video Connections: component, composite, SVHS

Dimensions: 435 x 171 x 431.5mm

Weight: 15kg

Accessories: remote control

Downloads

service manual  English

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


Reviews

 Login or register to post reviews

rating
Submitted by mitchalee

I did not expect good sound from the phono input on this 5.1 Receiver. But it is not bad. Other than my Onkyo TX-840, I like it better than any of my dozen vintage receivers from when the LP was king-- and a high design priority. I think it edges out the Sansui AU-5500. Of course my Nakamichi 610 preamp kills it. And I like the sound of my old tube Dyna PAS preamp a lot better. But in the world of receivers I will go even farther than not bad. It is listenable and, yes, enjoyable. An unexpected treat from Yamaha.

 

Comments

This website is not affiliated with or sponsored by Yamaha. To purchase HTR-5280 spares or accessories, please contact the company via their website or visit an authorised retailer.