hifi engine

adjustment for a tonearm


I have a Kenwood KD 64f. The linear tonearm sets on the outer edge of the record instead of the vinyl groove. I purchased this used without the manuel. How do you set the tonearm to set in the vinyl groove> Thank you, Mike

Check for an adjustment

Check for an adjustment screw. It might be under a small rubber/ plastic removeable cap. Usually located on the left side of the tone arm base or to the immediate left of the tone arm. Once you access the screw turn one way or the other until arm drops as it should.

kenwood 64f

Thanks Kickingbird2. After reading your response, I got the courage to look more seriously-found a adjustment to the left of the tone arm like you said. Tried one way, then the other which worked perfectly. I appreciate your help very much.