hifi engine

Kenwood KT 2020L Tuner- need user manual or advice on using memory for pre-sets

I have owned this tuner for many years, but all the pre-set memories have gone, and I can't find the original manual. I'm hoping somoene on the site might have it, or if not can give me instructions on how to set the memory pre-sets.

Thanks

Mark



Re: Kenwood KT 2020L Tuner- need user manual or advice on ...

If the memory does not work (stations disappear when power is off), then your memory capacitor is bad. I think yours is probably .047F at 5.5 volts; it will be near the microprocessor IC (usually an 80 pin chip).

Re: Kenwood KT 2020L Tuner- need user manual or advice on ...

Better late than never.
Enter frequency required as follows.
Direct 100.90 This will give you 100.9mhz.
deside your preset and then press entre and preset number.
Simple