hifi engine

Sentec SCA-1 control amplifier

Hi,
I just bought a control amplifier (or preamp.) built by the Swedish company Sentec. The manual says that the amplifier is factory configured for either MM or MC. At the rear of the amplifier there is a small sticker saying MC, so I suppose my amp. is configured with an MC phono input stage. Now to my question: I want to use my favourite MM cartridge together with this amplifier. 1) Can I change components on the phono preamplifier boards for MM input levels, or 2) do I need to replace the complete boards ?
In case of 1), which components need to be changed ?
In case of 2), is there anybody out there with MM boards that want to swap to MC phono input boards ?
/Tommy Andersson, Sweden



Sentec SCA-1 control amplifier

See manual... some jumpers needs to be moved/changed/added/replaced/soldered...

Sentec SCA-1 control amplifier

I am not familiar with your amp, but I would open the case to see if there is an internal switch for MM or MC.