hifi engine

Manual Library / Akai

Akai AM-A200

Stereo Integrated Amplifier (1986)

add a review (1 review)

Akai AM-A200

Specifications

Power output: 35 watts per channel into 8Ω (stereo)

Frequency response: 5Hz to 100kHz

Total harmonic distortion: 0.3%

Damping factor: 30

Input sensitivity: 2.5mV (MM), 250mV (line)

Signal to noise ratio: 70dB (MM), 90dB (line)

Channel separation: 50dB (line)

Speaker load impedance: 8Ω to 16Ω

Downloads

Related Catalogues

Audio Video

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.

Reviews

 Login or register to post reviews

rating
Reviewed Mar 30th, 2019 by moparfreak13

I bought it new in 1986. Once the outputs got shorted together and burnt the amplifier out. Really smelled bad, smoked, the whole thing... Had it serviced at a local repair center, but 2 speaker channels are still dead, I took it back to them, and they weren't interested in looking at it again, they said it's too oddball. The other two outputs work great, no problems other than some of the sliders get dirty and you have to run them up and down a few times to clean them every once in a while. It's got a ton of hours on it, so I guess they built it pretty good overall. Still sounds great.

 

Comments

This website is not affiliated with or sponsored by Akai. To purchase AM-A200 spares or accessories, please contact the company via their website or visit an authorised retailer.