hifi engine

Manual Library / Classe Audio

Classe Audio CA-200

Power Amplifier

add a review (1 review)

Classe Audio CA-200

Specifications

  • Power output: 200 watts per channel into 8Ω (stereo), 700W into 8Ω (mono)

    Frequency response: 20Hz to 20kHz

    Total harmonic distortion: 0.004%

    Gain: 29.02 dB

    Input sensitivity: 1.3V

    Signal to noise ratio: 135dB

    Speaker load impedance: 4Ω (minimum)

    Dimensions: 19 x 18.5 x 7.75 inches

    Weight: 60lbs

  • Power output: 200 watts per channel into 8Ω (stereo), 700W into 8Ω (mono)

    Frequency response: 20Hz to 20kHz

    Total harmonic distortion: 0.004%

    Gain: 29.02 dB

    Input sensitivity: 1.3V

    Signal to noise ratio: 135dB

    Speaker load impedance: 4Ω (minimum)

    Dimensions: 19 x 18.5 x 7.75 inches

    Weight: 60lbs

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed May 09th, 2016 by tutor turtle

Massively difficult to service. All outputs transistors (some 16 pairs) are soldered in. The bias resistors you need to sample to set the bias are buried under the output array, just inviting you to short-out the output circuit. The speaker protection circuit is so deeply buried in the assembly, I don't see how to access it while the power is on. Last, no where in this manual is a schematic of it or what it's monitoring. I'll update as I make headway, but I'm not encouraged, as I have a CA-400 (it's big brother) in with the same problem.

 

Comments

This website is not affiliated with or sponsored by Classe Audio. To purchase CA-200 spares or accessories, please contact the company via their website or visit an authorised retailer.