hifi engine

Manual Library / Dynaco

Dynaco Dynakit mkII

Power Amplifier Kit

add a review add a review

Dynaco Dynakit mkII

Description

Your Dynakit Mark II is a complete 50 watt power amplifier kit which offers the highest possible fidelity, at low cost and in a compact arrangement. It uses a circuit of outstanding performance characteristics, along with top quality parts, including the new Dynaco A-430 output transformer - the finest available.

The measured specifications show that the Dynakit is an amplifier of unequalled performance, and its listening quality is also unrivalled by any regardless of price.

The design features of your Dynakit which contribute to its superior listening quality do not show up in the usual steady-state laboratory specifications. For example, the Dynakit does not exhibit bounce and flutter when pulsed because of its wide margin of stability.

The Dynakit, unlike other amplifiers, has been designed to provide its specified performance on a loudspeaker load, not just a resistive load as in the laboratory. In particular, the connection of a loudspeaker does not distort the high frequency square wave performance.

In addition, the Dynakit's power handling capabilities are maintained over the entire audio band without the sharp rise in distortion which characterises most amplifiers at the low and high frequencies.

Specifications

Power output: 50W into 8Ω (mono)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 1%

Damping factor: 15

Input sensitivity: 1.5V

Signal to noise ratio: 80dB

Speaker load impedance: 8Ω to 16Ω

Valve complement: 2 x 6CA7/EL-34, 1 x 6AN8, 1 x 5U4GB

Dimensions: 9 x 9 x 6.75 inches

Weight: 27lbs

Downloads

Comments

This website is not affiliated with or sponsored by Dynaco. To purchase Dynakit mkII spares or accessories, please contact the company via their website or visit an authorised retailer.