hifi engine

Manual Library / Dynaco

Dynaco PAM-1

Dynakit Preamplifier

add a review add a review

Dynaco PAM-1

Description

The Dynakit PAM-1 preamplifier is a versatile control unit which permits using any modern program source with your Dynakit or other power amplifier.

This preamplifier uses a new circuit (patent pending) in which both voltage and current feedback loops include every tube section.

These feedback loops give tremendous stability and consistency of performance, greatly reduced distortion, and exceptionally low noise.

Specifications

Frequency response: 6Hz to 60kHz

Total harmonic distortion: 0.1%

Gain: 54dB (MM), 20dB (line)

Signal to noise ratio: 70dB (MM)

Valve complement: 2 x 12AX7 (ECC83)

Downloads

Comments

This website is not affiliated with or sponsored by Dynaco. To purchase PAM-1 spares or accessories, please contact the company via their website or visit an authorised retailer.