hifi engine

Manual Library / Eumig

Eumig M-1000

Stereo DC Power Amplifier

add a review add a review

Eumig M-1000

Specifications

Power output: 100 watts per channel into 8Ω (stereo)

Frequency response: 1Hz to 300kHz

Damping factor: 50

Signal to noise ratio: 95dB

Year: 1979

Downloads

Comments

steve's picture

re: M-1000

Quality amp built by Luxman in the pre- Alpine era. Has a switch for electrostatics. Runs 2 Ohm loads with no difficulty. Uses freon cooling system seen on some luxman amps of the era.

This website is not affiliated with or sponsored by Eumig. To purchase M-1000 spares or accessories, please contact the company via their website or visit an authorised retailer.