hifi engine

Manual Library / Harman Kardon

Harman Kardon 630

AM/FM Stereo Solid State Receiver

add a review (2 reviews)

Harman Kardon 630

Specifications

Tuning range: FM, MW

Power output: 30 watts per channel into 8Ω (stereo)

Frequency response: 4Hz to 70kHz

Total harmonic distortion: 0.5%

Signal to noise ratio: 85dB (line)

Dimensions: 12 x 13-3/4 x 4-3/4 inches

Weight: 28lbs

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Jan 23rd, 2019 by Goodlucktrev

This 630 had been stored for years but given a clean and plugged into a Bluetooth receiver it plays Spotify all day. It is a quality amp with a warm pleasant sound. I have matched it with new Dali Spektor2 speakers and an old Dual CS503 turntable as it has a nice pre-amp phono setup. The control knobs are solid aluminium alloy and it even has dual channel split bass & treble control. The dual power supply gives plenty of power to the speakers way above the stated RMS/channel.

rating
Reviewed Jun 02nd, 2018 by birchoak

Dual mono (two transformers), clean internal layout, very robust construction with delightfully knurled, solid aluminum knobs. Dial lights shut off automatically when FM/AM not in use. Output transistors mounted outside rear panel, inside metal grill, for maximum heat dissipation. Can be used as a pre-amplifier to good effect. Warm sound, very attractive, clean look especially without optional wood case.

 

Comments

re: 630

I bought mine in 1974 from a local HiFi shop here in Australia. It cost me A$340 (I found the receipt today). My daughter is taking possession of it tomorrow. $340 would probably have been about 1-1/2 week's wages at the time (I was on good money as an electronics tech).

re: 630

Found my 630 Harman Kardon at Goodwill sounds great had to by a new balance nob, new lights and cleaned it up nice receiver.

This website is not affiliated with or sponsored by Harman Kardon. To purchase 630 spares or accessories, please contact the company via their website or visit an authorised retailer.