hifi engine

Manual Library / Jensen

Jensen TP-200

3-Way Reproducer (1957)

add a review add a review

Jensen TP-200


The Jensen TP-200 Tri-Plex Reproducer is the finest reproducing instrument that modern science can provide in such moderate size.

The design objectives set for the Tri-Plex were quite demanding. A reproducer was required having performance noticeably superior to anything heretofore available, with size and styling acceptable in the home.

Reproduction was to be flawless with smooth, extended output at both ends of the spectrum, and with uniformly wide angular coverage.

Power handling capacity adequate for the largest room and efficiency quite high so as to accommodate the amplifiers of lower rating were mandatory.

However, it was considered of greatest importance to give unusual and detailed attention to the important middle register where the ear is most sensitive and can discern the slightest abnormality.

Not only must distortion of all kinds be reduced to the vanishing point but every possible step taken to achieve an extremely smooth and well-balanced loudspeaker system.


Type: 3 way, 3 driver loudspeaker system

Power Handling: 35W

Crossover Frequency: 600, 4000Hz

Impedance: 16Ω

Bass: P15-LL

Midrange: RP-201

Tweeter: RP-302

Finish: mahogany, blonde korina

Dimensions: 38-5/8 x 26 x 19-7/8 inches

Weight: 124lbs

Year: 1957


Related Catalogues

High Fidelity Loudspeaker Systems

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


This website is not affiliated with or sponsored by Jensen. To purchase TP-200 spares or accessories, please contact the company via their website or visit an authorised retailer.