hifi engine

Manual Library / JVC


Stereophonic Headphones (1971-72)

add a review (1 review)



The STH-10E operates over a wide 20-20,000Hz frequency range and has a distortion factor of less than 1% at rated output.

Featuring a moving coil design, each headphone has four holes in the back of the speaker, three of them blocked to better achieve a flat frequency characteristic.

Each is also equipped with a large 70mm diaphragm to obtain better radiation effects even at the lowest frequencies.

The STH-10E also features an adjustable headband and ultra-soft ear pads, for increased comfort and enjoyment.


Type: moving coil headphone

Frequency Response: 20Hz to 20kHz

Nominal load: 1mW

Maximum input: 500mW

Total harmonic disortion: 1%

Impedance: 8Ω

Cord Length: 300cm

Weight: 360g


Related Catalogues

HiFi Programm

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


 Login or register to post reviews

Reviewed Jun 17th, 2019 by peter1

I just love these vintage headphones put them on and the outside is blocked out and is just me an the music. I have them connected them to a Trio KA-2002 amp which was also made in the very early 70's so a perfect match.



This website is not affiliated with or sponsored by JVC. To purchase STH-10E spares or accessories, please contact the company via their website or visit an authorised retailer.