hifi engine

Manual Library / KEF


Powered Subwoofer System (2002)

add a review add a review



Type: single driver subwoofer

Frequency Response: 35Hz to 140Hz

Sub Bass: 1 x 250mm B250 long throw cone

Enclosure: bass reflex

Finish: Video Grey

Dimensions: 435 x 400 x 400mm

Weight: 25.3kg

Note: built in 300W power amplifier

Year: 2002



re: PSW3000

Hello, I'm wondering how much resistance should have speaker conected to the speakers output terminals?

re: PSW3000


The speaker jacks on the back of the subwoofer are just there to pass the signal through from the amp / receiver to the speakers and allow the sub to tap into the bass signal. So the speakers should be matched to the amp / receiver. If the existing system was working fine and you are just adding the subwoofer, then everything will be fine.


re: PSW3000

Thank you for quick and very helpful comment.

Best regards

This website is not affiliated with or sponsored by KEF. To purchase PSW3000 spares or accessories, please contact the company via their website or visit an authorised retailer.