hifi engine

Manual Library / Kenwood

Kenwood KA-2002

Solid State Stereo Amplifier

add a review (5 reviews)

Kenwood KA-2002


Power output: 13 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 30kHz

Total harmonic distortion: 0.8%

Damping factor: 50

Input sensitivity: 2mV (MM), 150mV (line)

Signal to noise ratio: 60dB (MM), 70dB (line)

Output: 150mV (line), 30mV (DIN)

Semiconductors: 22 x transistors, 10 x diodes, 2 x thermistors

Dimensions: 330 x 115 x 240mm

Weight: 4.8kg



 Login or register to post reviews

Reviewed Dec 13th, 2017 by peter1

Nice and detailed sound plus much nicer looking than the later 2002A.

Reviewed Jun 08th, 2017 by ts1810

Betters a Leben CS300XS I used to have, what else you can say for this little miracle.

Reviewed Dec 30th, 2016 by dDavidd

Very good sound, in my opinion better than the KA 4002;I tested these with B&W matrix 3 speakers...

Reviewed Dec 02nd, 2016 by freddyjazz

Hi, I buy this ampflier with very good results. The music on my B&W 802 are wonderful, beautifull detail and warm sound with high and low. And that for a amp from 1970 with new c.

Reviewed May 19th, 2016 by kitchenbug

Solid little guy.



This website is not affiliated with or sponsored by Kenwood. To purchase KA-2002 spares or accessories, please contact the company via their website or visit an authorised retailer.