hifi engine

Manual Library / Kenwood

Kenwood KA-5050R

Stereo Integrated Amplifier (1993-95)

add a review (1 review)

Kenwood KA-5050R


Power output: 80 watts per channel into 8Ω (stereo)

Frequency response: 5Hz to 100kHz

Total harmonic distortion: 0.04%

Damping factor: 220

Input sensitivity: 0.2mV (MC), 2.5mV (MM), 200mV (line)

Signal to noise ratio: 68dB (MC), 87dB (MM), 104dB (line)

Output: 200mV (line)

Dimensions: 440 x 147 x 403mm

Weight: 12kg

Accessories: remote control

Year: 1993


Related Catalogues


If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


 Login or register to post reviews

Reviewed Feb 03rd, 2018 by ravenman

Casual consumer amplifier which is gem - very good MOSFET poweramp transistors and nice construction, after relay cleaning, repaired solder joints and most important thing - re-biasing it from nasty low factory 10mV (50 mA) to 20 mV is fantastic musical sounding amp, mosfet is so close to valve operation . After bias setting its runs a lot hotter , but in 20 mV region is acceptable , best should be about 28 - 30 mV (same as higher model- flagship 7050) , but i do not try because heat dissipation. Very recommended, preamp is also simple and relay driven with short signal path - no big loss in clarity and resolution in music. This is surprise machine for me, because my ears is trained with fully class A amps from Luxman and Accuphase.




Fantastique petit ampli, robuste et au look intemporel!

This website is not affiliated with or sponsored by Kenwood. To purchase KA-5050R spares or accessories, please contact the company via their website or visit an authorised retailer.