hifi engine

Manual Library / Kenwood

Kenwood KR-3060

AM/FM Stereo Receiver

add a review add a review

Kenwood KR-3060

Specifications

Tuning range: FM, MW

Power output: 22 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 50kHz

Total harmonic distortion: 0.8%

Damping factor: 35

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 70dB (MM), 90dB (line)

Output: 150mV (line), 30mV (DIN)

Speaker load impedance: 4Ω to 16Ω

Dimensions: 500 x 140 x 300mm

Weight: 8.7kg

Downloads

Comments

re: KR-3060

Unfortunately, this model is frequently confused with the KR-A3060 from the 1990's, it ain't the same. For a slightly above "basic" unit this Kenwood gives you a very good FM front end and a very rare (in this price range) high filter. At 22wpc it won't knock down walls but it's honest power and enough to drive efficient speakers like the EPI-100's to neighbor annoying levels. THD and IM of 0.8% was acceptable for mid 1970's basic+ receivers. Would have liked a signal strength meter too and another tape loop but it does have an AUX input. I like the blacked out (back lit) dial scale, very slick and stylish. For a medium size room with speakers from EPI, Genesis, AR, Micro Acoustics etc. this receiver could be the heart of a nice, vintage sound system. Quality built with that Kenwood semi-industrial look.

This website is not affiliated with or sponsored by Kenwood. To purchase KR-3060 spares or accessories, please contact the company via their website or visit an authorised retailer.