hifi engine

Manual Library / Kenwood

Kenwood KR-5010

DC Stereo Receiver

add a review add a review

Kenwood KR-5010

Specifications

Tuning range: FM, MW

Power output: 45 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.03%

Damping factor: 28

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 82dB (MM), 105dB (line)

Output: 150mV (line), 30mV (DIN)

Speaker load impedance: 4Ω to 16Ω

Dimensions: 471 x 139 x 358mm

Weight: 8.6kg

Downloads

Comments

re: KR-5010

Just repaired a KR-5010. It had a dead short that I traced to the voltage amplifier, IC TA-1001. I decided to also replace the two darlington arrays: STK0050. The TA-1001 is made of the dreaded "unobtanium". Did some research and figured that STK3042II would be a suitable substitute for the TA-1001. I thought the STK0050II would be a upgraded version of the STK0050, so I purchased a pair of those. Short story shorter: substitutes work great!
Paul, AF7HT

This website is not affiliated with or sponsored by Kenwood. To purchase KR-5010 spares or accessories, please contact the company via their website or visit an authorised retailer.