hifi engine

Manual Library / Kenwood

Kenwood KR-7200

AM/FM Stereo Receiver (1972-74)

add a review (1 review)

Kenwood KR-7200


Tuning range: FM, MW

Power output: 55 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 40kHz

Total harmonic distortion: 0.5%

Damping factor: 50

Input sensitivity: 1.25mV (mic), 2.5mV (MM), 180mV (line)

Signal to noise ratio: 55dB (mic), 65dB (MM), 75dB (line)

Output: 180mV (line), 36mV (DIN)

Speaker load impedance: 4Ω to 16Ω

Semiconductors: 3 x FET, 1 x IC, 61 x transistors, 42 x diodes, 1 x thermistor

Dimensions: 17-1/8 x 5-3/4 x 14 inches

Weight: 29.5lbs

Finish: walnut cabinet


Related Catalogues


If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


 Login or register to post reviews

Reviewed Dec 19th, 2015 by Clontarf

I have two of these receivers, and they are both very strong performers. I had to restore both of them to some extent. The sound is astounding with good speakers. I just recently married off a daughter, and one of these, plus a pair of Bose 901s, provided the sound for the reception party. It was outside, next to a lake, yet the system had no problem overcoming the lousy acoustics. The microphone plug-in was very handy for the usual wedding announcements. There were many compliments on the sound and music, which was provided by a laptop computer, connected by a y-plug through the AUX input.



re: KR-7200

Very nice Kenwood. Warm rich nice sound.

This website is not affiliated with or sponsored by Kenwood. To purchase KR-7200 spares or accessories, please contact the company via their website or visit an authorised retailer.