hifi engine

Manual Library / Kenwood

Kenwood KR-V9080

Audio Video Surround Receiver

add a review add a review

Kenwood KR-V9080


Tuning range: FM, MW

Power output: 150 watts per channel into 8Ω (stereo)

Surround output: 150W (front), 150W (center), 65W (rear)

Frequency response: 10Hz to 75kHz

Total harmonic distortion: 10%

Input sensitivity: 2.5mV (MM), 200mV (line)

Signal to noise ratio: 75dB (MM), 98dB (line)

Output: 200mV (line), 1V (Pre out)

Speaker load impedance: 4Ω to 16Ω

Video Connections: composite, SVHS

Dimensions: 440 x 162 x 396mm

Weight: 12.8kg

Accessories: remote control



Kenwood KR-V9080. No rear channel or subwoofer operation?

Does anyone know if this model is prone to some sort of "Fuse resistor" burnout, causing only the front channels to operate? I know this item was made in China, and I don't expect miracles from the circuitry, but I do like the load tracking cooling fan. I've used the GUI, and I have the proper remote, which I bought new. But, no rear end, even though the GUI shows the rear volume is turned up.

Please let me know if you have some familiarity with this condition, or if you had this model repaired. Thanks....

re: Kenwood KR-V9080. No rear channel or subwoofer operation?

Hi buddy,
its late, I know.
But is the flaw actual yet?

This website is not affiliated with or sponsored by Kenwood. To purchase KR-V9080 spares or accessories, please contact the company via their website or visit an authorised retailer.