hifi engine

Manual Library / McIntosh

McIntosh MHT200

Audio Video System Controller

add a review (1 review)

McIntosh MHT200

Specifications

Tuning range: FM, MW

Power output: 70 watts per channel into 8Ω (stereo)

Surround output: 70W (front), 70W (center), 70W (rear), 70W (sub)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.05%

Damping factor: 200

Input sensitivity: 100mV (line)

Signal to noise ratio: 90dB (line)

Speaker load impedance: 4Ω (minimum)

Digital inputs: coaxial, optical

Video Connections: component, composite, SVHS

Dimensions: 450 x 240 x 483mm

Weight: 33.1kg

Accessories: remote control, optional TM-1 AM/FM tuner module

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Nov 30th, 2016 by Auxiliary

Superb sounding amplifier. Very intuitive and easy to control. Hence the 8ch input, it is still good choice with a modern BR-player. Of course, if you want Dolby Atmos or alike, this is outdated. FM section just fair, if installed. Separate HDMI-switcher needed though.

 

Comments

McIntosh MHT100 repair, may apply to 200 also

MHT 100 does not power up or only for a short time:

Have a look at switching power supply on the side where the power input is.
This is from China Meanwell type PT65C and easily available.

The rated output voltages are +5, +15 and -15 volts on the multiconnector.
Check from top on the main board. 5V are on the middle pins. If too low try
to adjust with the white pot on the supply board, only slightly above, say 5.1volts.

Save "lifetime" of the supply by switching the unit off with the black main switch.

Thiese hints may apply to type MHT 200 also. In the 200 service manual this
supply is called "backup supply" and is said to be adjusted to even 5.3 volts.

MHT 100 and 200 look alike from what I can see in the papers for 200.

re: McIntosh MHT100 repair, may apply to 200 also

The service manual says to "SET R1 FOR 5.3VDC AT PIN 2 OF CONNECTOR CN2"

This website is not affiliated with or sponsored by McIntosh. To purchase MHT200 spares or accessories, please contact the company via their website or visit an authorised retailer.