hifi engine

Manual Library / Mitsubishi

Mitsubishi DA-A10DC

Stereo Power Amplifier (1978)

add a review (2 reviews)

Mitsubishi DA-A10DC

Specifications

Power output: 100 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.005%

Damping factor: 100

Input sensitivity: 1V

Signal to noise ratio: 107dB

Dimensions: 425 x 170 x 285mm

Weight: 16kg

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Sep 15th, 2017 by NADWood

They just don't make them like this anymore. Almost 40 years old and still has never failed me. The most conservative sounding 100 wpc amp I've ever owned. It's downright debateable. But the warmth and power it brings makes every preamp I've mated to sound there best.

rating
Reviewed Nov 13th, 2015 by Ralph Aroni

I bought one of these new back in the day and have recently gotten it back after many years of storage. In their price range these were superb amplifiers. For at least 10 years mine ran a set of 4 speakers with a combined resistance well below 4 ohms. It was commonly used near or at its limits and never had any problems. The sound was very clean and sharp. The dual mono setup and the then massive capacitors and the huge heat sinks kept it running cool. Even today after all of this time it is in good working order.

 

Comments

This website is not affiliated with or sponsored by Mitsubishi. To purchase DA-A10DC spares or accessories, please contact the company via their website or visit an authorised retailer.