hifi engine

Manual Library / Mitsubishi

Mitsubishi DA-C7

Tuner Pre Amplifier

add a review add a review

Mitsubishi DA-C7

Specifications

Frequency response: 10Hz to 70kHz

Total harmonic distortion: 0.003%

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 75dB (MM), 99dB (line)

Output: 150mV (line), 1V (Pre out), 10V (Pre out Max)

Dimensions: 425 x 170 x 292mm

Weight: 7.5kg

Downloads

Comments

re: DA-C7

I have the C7 with an A70C amp. Using the amp powered through the C7, there is never a "thump" or DC surge through the speaker wire.

Measured DC offset at the output terminals was all within a few millivolts and all were below 5mv, which is exceptional, IMO.

re: DA-C7

I really think these preamps fly under the radar, I have a P20 and the C7. It seems the C-7 does not have a relay click at power up, and the P20 does, you really have to watch and turn off the amp first and turn this preamp on first in order to avoid the dreaded thump that can damage speakers.

This website is not affiliated with or sponsored by Mitsubishi. To purchase DA-C7 spares or accessories, please contact the company via their website or visit an authorised retailer.