hifi engine

Manual Library / Monacor

Monacor SA-800

Solid State Stereo Amplifier

add a review (1 review)

Monacor SA-800

Specifications

Power output: 40 watts per channel into 8Ω (stereo)

Frequency response: 5Hz to 70kHz

Total harmonic distortion: 0.4%

Input sensitivity: 2.2mV (mic), 2.5mV (MM), 150mV (line)

Signal to noise ratio: 65dB (mic), 65dB (MM), 75dB (line)

Output: 150mV (line)

Semiconductors: 3 x IC, 25 x transistors, 7 x diodes

Dimensions: 16 x 5-1/8 x 11-1/2 inches

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Sep 13th, 2015 by dimk25

like this amp.. he is alive.. wide scene .. I am a happy owner of this model. I replaced the original capacitor in the preamplifier and power amplifier... I set ELNA cerafine and SILMIC 2 and get a good result in terms of sound. True waited a long time until all ingredients will get used to each other ( about a week intensively chasing the amplifier at high and medium volume ) . I will not say that it is outstanding, but it is worth paying attention!

 

Comments

This website is not affiliated with or sponsored by Monacor. To purchase SA-800 spares or accessories, please contact the company via their website or visit an authorised retailer.