hifi engine

Manual Library / NAD

NAD 1240

Stereo Pre Amplifier

add a review add a review

NAD 1240

Specifications

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.01%

Input sensitivity: 0.1mV (MC), 1.5mV (MM), 90mV (line)

Signal to noise ratio: 75dB (MC), 85dB (MM), 96dB (line)

Output: 9V (Pre out)

Dimensions: 420 x 76 x 260mm

Weight: 4.25kg

Downloads

Comments

Beefcurtanz's picture

NAD 1240

Picked this up at the local pawn shop. I love it, awesome phono section, lots of line inputs, and very easy to service. The bottom panel comes off to give full access to the bottom of the 1 main board. You can solder out/in whatever you need to without removing anything but the top and bottom panels. Just an FYI, there are a couple capacitor # errors on the service manual, correct values, just different designators. The volume control is smooth, it has the balance in the center of the volume knob.

re: NAD 1240

I just picked up a NAD 1240 preamp and a NAD 214 Power amp for $10 and I think it sounds as good as my Carver M500 and possibly better.

This website is not affiliated with or sponsored by NAD. To purchase 1240 spares or accessories, please contact the company via their website or visit an authorised retailer.