hifi engine

Manual Library / NAD

NAD 300

Stereophonic Receiver

add a review add a review

NAD 300


Tuning range: FM, MW

Power output: 85 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 20kHz

Total harmonic distortion: 0.03%

Input sensitivity: 2.2mV (mic), 3mV (MM), 200mV (DIN), 200mV (line)

Signal to noise ratio: 63dB (MM), 85dB (line)

Channel separation: 50dB (line)

Output: 200mV (line), 30mV (DIN)

Dimensions: 508 x 400 x 145mm

Weight: 22kg



NAD model 300


Thank you very much for the schematic. I just bought a NAD model 300 in very good condition. Only three meter-lights are not working, thus this schematic was very handy in finding the correct ones. Also the string of the tuner has been repaired, but i want to redo this, but i do not know the correct setup for this. I could use the repair/maintenance manual/guide, is it possible to upload that?


This website is not affiliated with or sponsored by NAD. To purchase 300/model 300 spares or accessories, please contact the company via their website or visit an authorised retailer.