hifi engine

Manual Library / NAD

NAD AV711

Audio Video Receiver (1996)

add a review add a review

NAD AV711

Description

Most A/V receivers available on the market today focus predominantly on the Video and Surround Sound aspects, leaving the audio circuitry almost as an afterthought.

With NAD’s reputation for high value / high performance it was obvious that the Model AV 711 would have to please Audiophiles and Videophiles alike.

By doing away with many costly and superfluous features, NAD’s designers concentrated only on the truly important parts of an A/V receiver.

The NAD Model AV 711 uses discrete output stages only, including the surround channels. The benefits of this approach have been proven over the years in many acclaimed NAD amplifiers and receivers.

The integrated output modules favoured by so many other designs will deliver a decent amount of power under laboratory conditions, driving an 8 ohms resistor, but can have great difficulties in driving moderately difficult speakers.

Using circuitry derived from NAD’s renowned EDP technology, the NAD Model AV 711 will drive 4 ohms loudspeakers with ease and deliver high amounts of dynamic power.

Specifications

Tuning range: FM, MW

Power output: 40 watts per channel into 8Ω (stereo)

Surround output: 40W (front), 20W (rear)

Frequency response: 5Hz to 50kHz

Total harmonic distortion: 0.08%

Damping factor: 60

Input sensitivity: 150mV (line)

Signal to noise ratio: 95dB (line)

Output: 1V (Pre out)

Speaker load impedance: 4Ω (minimum)

Video Connections: composite

Dimensions: 435 x 147 x 331mm

Weight: 8.4kg

Accessories: remote control

Downloads

Comments

This website is not affiliated with or sponsored by NAD. To purchase AV711 spares or accessories, please contact the company via their website or visit an authorised retailer.