hifi engine

Manual Library / NAD

NAD AV716

Surround Sound Receiver

add a review (2 reviews)

NAD AV716

Specifications

Tuning range: FM, MW

Power output: 80 watts per channel into 8Ω (stereo)

Surround output: 55W (front), 55W (center), 20W (rear)

Frequency response: 20Hz to 30kHz

Total harmonic distortion: 0.08%

Damping factor: 60

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 80dB (MM), 100dB (line)

Speaker load impedance: 4Ω (minimum)

Video Connections: composite

Dimensions: 455 x 168 x 375mm

Weight: 13.2kg

Accessories: remote control

Downloads

Reviews

 Login or register to post reviews

rating
Reviewed Jun 13th, 2016 by Gizmo1970

Verry nice Receiver with smooth looks, and realy Great Sound and Power in it !
With a 3 mode soundlevel.
Stereo with 80 Watt by 8 Ohm RMS per channel.
And Surround sound, with 55 Watt on the frontspeakers and Centerspeaker, and 20 Watt on the Backspeakers. Nice for movies this !
And Hall, where you can play the Front- and Backspeakers together.
You can also hook on a Active Subwoofer ! This is not nescecerry because there's good Bass allready.
But you can, and gives a great Bass !
You can even plug on an extra set of speakers for a Second room on it !
The volume can be done seperately for the Backspeakers and centerspeaker, or the Second-room speakers !
And there is a remote Control.
Take note that the receiver is a bit Higher then most receivers !

rating
Reviewed Jun 11th, 2016 by gelone69

Superb sound, I use it in stereo mode,

 

Comments

This website is not affiliated with or sponsored by NAD. To purchase AV716 spares or accessories, please contact the company via their website or visit an authorised retailer.