hifi engine

Manual Library / Onkyo

Onkyo TX-88

AM/FM stereo receiver

add a review add a review

Onkyo TX-88

Specifications

Tuning range: FM, MW

Power output: 80 watts per channel into 8Ω (stereo)

Frequency response: 20Hz to 30kHz

Total harmonic distortion: 0.025%

Damping factor: 50

Input sensitivity: 2.5mV (MM), 150mV (line)

Signal to noise ratio: 76dB (MM), 80dB (line)

Output: 150mV (line)

Video Connections: composite

Dimensions: 450 x 147 x 460mm

Weight: 12.5kg

Downloads

Comments

re: TX-88

I repaired one of these for someone earlier this year. It had a fusible resistor open and a shorted cap in the standby supply. Also, some caps in the protection circuit had become leaky (electrically). Anyways, since I own some decent test equipment, I figured I'd take some measurements. Both channels tested the same. The unit produced 82 Watts per channel, both driven into 8 ohms at .003% THD+N 1kHz. If we take the noise component out, the only harmonically related components were about 0.001%! The 19+20kHz IMD test resulted in the 1kHz difference being 105dB down or about 0.00056%. Very impressive. It has the best measured performance of any amp/receiver that's come to me for service so far.
I never had time to seriously listen to it, though.

This website is not affiliated with or sponsored by Onkyo. To purchase TX-88 spares or accessories, please contact the company via their website or visit an authorised retailer.