hifi engine

Manual Library / Pioneer

Pioneer SA-400

Stereo Integrated Amplifier (1967-70)

add a review add a review

Pioneer SA-400


Power output: 11 watts per channel into 8Ω (stereo)

Frequency response: 30Hz to 20kHz

Total harmonic distortion: 1%

Damping factor: 13

Input sensitivity: 2.3mV (MM), 38mV (ceramic), 150mV (line)

Signal to noise ratio: 60dB (MM), 80dB (line)

Speaker load impedance: 8Ω to 16Ω

Valve complement: 12AX7, 6BM8

Dimensions: 352 x 260 x 135mm

Weight: 7kg

Year: 1967


Related Catalogues

Hi-Fi Stereo

If you have any problems opening files please read the download FAQ. All files are provided under strict licence and reproduction without prior permission or for financial gain is strictly prohibited.

If you have additional documentation please consider donating a copy to our free archive.


colin44ct357's picture

re: SA-400

Good Day All
As i left valve in the 80's I was wondering if anyone can guide me to which caps to replace as the amp was re-tubed but audio still very low.
Thanks for the GR8 site and all contributors like IVY...a shining star in the abyss.
Colin Cape Town.

re: SA-400

That age as SA-400 are its a wise to change all the electrolytics to fresh ones. And other caps to the plastic ones. Even a Mylar/Polyester are great. And those soldering poits must re-solder. Its a wise to use thin solder - no more than 1mm size diameter. Old carbon resistors are mostly problem ones.

This website is not affiliated with or sponsored by Pioneer. To purchase SA-400 spares or accessories, please contact the company via their website or visit an authorised retailer.